Fine Aggregate Replacement
Siddique et al. (2009) partially replaced fine aggregate (regular sand) with WFS in three percentages (10%, 20%, and 30%) by weight and evaluated the compressive strength, …
اقرأ أكثرSiddique et al. (2009) partially replaced fine aggregate (regular sand) with WFS in three percentages (10%, 20%, and 30%) by weight and evaluated the compressive strength, …
اقرأ أكثرThis project present the usage of copper slag for the partial replacement for fine aggregate the experimental procedure is conducted for the replacing percentage of 10%,15%,20%.for this …
اقرأ أكثرFrom the Fig. 8, Fig. 9, it is observed that due to replacement of fine aggregate with copper slag excess of water gets stagnant in concrete and leaves more …
اقرأ أكثرIn Group 3, wood waste aggregate has been used as a partial replacement of 10%, 15%, 20%, 25% and 30% by volume of coarse aggregate. The specimens were conditioned for 28-days at 80±5% Relative ...
اقرأ أكثر5) Mixtures with 0% and copper slag replacement gave the lowest compressive strength value of Approximately 30 MPa, which was almost 16% lower than the strength of the control …
اقرأ أكثرThe experimental results show that: 30 wt.% and 100 wt.% mixed sand has more fine aggregate, poor grading, and the measured value is greater than 1.4. With the …
اقرأ أكثرThis paper is about the experimental study of the replacement of copper slag for fine aggregate in concrete. In this study, M40 Grade concrete was considered to study the strength of concrete...
اقرأ أكثرReplacement of copper slag in fine aggregates reduces the cost of making concrete. Replacement of copper slag increases the self weight of concrete specimens to the …
اقرأ أكثرEnter the email address you signed up with and we'll email you a reset link.
اقرأ أكثرwaste was mostly supplanted by fine aggregates in 10%, 20%, 30%, 40% and 50%. Neetu Susan Mathew and S.Usha (2016)[4] The outcomes demonstrated that geo polymer concrete with …
اقرأ أكثر